It’s not as if it hasn’t been done before, but here’s my take on this classic.
Categories
Recent Posts
- mattmillman.com on IPv6 once again
- Motor over-current/torque detection and limiting circuits
- Matt takes delivery of an MDPC-X “CTX3” crimp tool
- MCS-48: The quest for 16-bit division on the 8-bit CPU which can’t divide anything
- MDPC CTX3: A load of doubtful marketing bollocks lands on my crimp connectors page
Recent Comments
- Robbie on Specialty Electrical Tapes
- Carlo on Common wire-to-board, wire-to-wire connectors, and crimp tools
- Ralf Kapell on TDSScreenCap – An RS232 screen capture program for the Tektronix TDS3000 series
- admin on TDSScreenCap – An RS232 screen capture program for the Tektronix TDS3000 series
- Ralf Kapell on TDSScreenCap – An RS232 screen capture program for the Tektronix TDS3000 series
Archives
- December 2020
- November 2020
- October 2020
- September 2020
- August 2020
- July 2020
- June 2020
- May 2020
- April 2020
- March 2020
- February 2020
- January 2020
- December 2019
- July 2019
- June 2019
- May 2019
- February 2019
- January 2019
- June 2018
- May 2018
- April 2018
- September 2017
- August 2017
- June 2017
- May 2017
- January 2017
- August 2016
- May 2016
- November 2015
- October 2015
- September 2015
- June 2015
- April 2015
- March 2015
- February 2015
- November 2014
- June 2014
- May 2014
- April 2014
Hello I am just curious the second design schematic on your pulse DTMF tone is different than a month ago. Does this new one work or was it mistakenly uploaded. The Parts list still matches the original revised schematic.
Good observation!
They both work. The first one was unnecessarily complicated, so revised and re-uploaded it.
When I release the gerbers (in the coming weeks) – they will be for the present schematic.
Hello. A Danish F68 rotary dial telephone will add one to every digit dialed. Dialing 1 will come out as 2, 2 will come out as 3 and so on. I have looked through your code but I can’t seem to find a way to subtract 1 from every digit dialed. Could you please help me out?
A very simple change. You’d replace the code inside the NZ_DIAL define to do that. I’ll take a look at it when I get a chance.